Turbo Pump Rebuild Service

PTB Sales does not rebuild turbo pumps or repair controllers organically; however, the company has successfully offered this service dating back to 2002. We have a robust network of partners who perform these rebuilds and repairs as well as an equally strong network of suppliers providing new equipment. In addition, our experience over the last decade gives us a thorough knowledge of which companies provide the best workmanship and quality on the different turbo pump types by OEM. The warranty period is up to twelve months on all rebuilds/repairs.

Proprietary database of service providers.
Independent quality standards.
600 serviced in the last two years.
1st level inspection.

Quality and reliability standards to comply with customers requirements:

All products delivered are free from defects in design, materials, workmanship and fabrication.
All services performed will be performed at OEM service levels and tested to OEM standards.
The rebuilt turbo pumps will conform fully to applicable specifications, drawings and other criteria specified by OEM and/or customer.

Turbo pump rebuild service includes:

Diagnostic check of motor, electromagnets, sensors and memory prior to tear down.
Complete decontamination of internal and external parts.
Disposition of toxic material in accordance with environmental regulations.
Inspection of critical stress points on all major and minor components.
All stainless bolts, seals, and O-rings replaced with new.
Use of new OEM bearings.
A report of any replacement of parts required that are not included in a standard repair (i.e. broken blades, bent shaft, damaged rotor, etc).
Motor balancing to meet or exceed OEM specifications.
Vibration analysis.
Leak check.
Extended testing in customer specified orientation.
Pumps cleaned and polished for clean room application.
All labeled with instructions for safety and 100% startup.
Custom crating and packaging.
Complete failure analysis report upon request.

Turbo Controller Repair Service

Turbo controller repair service includes:

Run diagnostic check.
Repair and replace all bad components.
Repair trace and board damage.
Replace batteries.
Run test on subassemblies to ensure OEM specifications are met.
Test for tuning and levitation for magnetically levitated pump types.
Test under maximum load.
Tune and match to pump and cable set.
Test interface operation.