Home > Power Supplies > RF Plasma > Other Mfg. > SEREN IPS > SEREN IPS R301 RF Power Supply

SEREN IPS R301 RF Power Supply

90 Day Warranty 

Request for Quote

To request a quote, click the button below and fill out the form.

RFQ

Manufacturer Part Number: 9600730034
SEREN IPS R301 RF Power Supply
Click Image to Enlarge

SEREN IPS Industrial Power Systems R301MKII RF Power Supply

Questions? Please call our toll free number at 866-332-0500 or send an email to our sales team!

Voltage taps 98V, 115V, 208V, or 220V; single-phase, factory configured
Frequency 47 - 63 Hz
Power required 750VA maximum
Overcurrent protection Rear panel circuit breaker, 2x 3A ¼”x1-1/4” time-delay fuses
Current 98 - 125V: 10A Maximum 198 - 250V: 5A Maximum
Inrush current 36.2A nominal
Power cord for 98-125V models 14/3 Type SJT, 2m length, with IEC320-C13 female connector and NEMA 5-15P male plug
Power cord for 198-250V models     1/3 Type SJT, 2m length, with IEC320-C13 female connector and NEMA l6-15P male plug
Output power High range: 0 to 300 Watts into 50 Ohms
Low range: 0 to 30 Watts into 50 Ohms
Output frequency 13.56 MHz, crystal-controlled
Leveling Forward power, load (Net) power, external feedback (RF or DC probe)
Frequency stability 0.005% short-term
Power stability 0.5% long-term
Output impedance 50 Ohms, +/-5 Ohms nominal
Metering accuracy +/- 0.5% full scale
Forward power +/- 3% of reading
Temperature coefficient 0.25% per °C
Forward power regulation +/- 1% into 50 Ohms
Load tolerance No oscillation or failure into a mismatch condition
Protection Forward power limits on current, transistor power dissipation, and excessive reflected power. Unit is short-circuit and open-circuit protected. Unit is thermally protected.
Spurious radiation Designed to meet or exceed FCC requirements
Harmonics -50 dBc
Noise, hum & ripple -50 dBc
Ambient operating temperature 0 to +40°C
Operating relative humidity 10% to 90%, non-condensing
Cooling Forced air, 110 cfm
Analog interface 25 pin female D-Sub connector
Serial interface 9 pin female D-Sub connector
DCP (Probe) input (optional) Female type BNC connector, 0 to –10 VDC
CEX input Female type BNC connector, 3 to 8V peak-to-peak sine wave, 13.56 MHz
CEX output Female type BNC connector, 5 to 8V peak-to-peak, 13.56 MHz
Dimensions inch (mm) 5.25 (133.35) high x 9.50 (241.30) wide x 18.35 (466.09) deep, width without ½-rack mounting brackets: 8.00 (203.2)
Weight 43 lbs (19.5 kg)

Request for Quote

Need modifications to this item? PTB Sales' expert team of engineers can configure products to your specific needs. Please follow the above link, and fill out the quote form.

SEREN IPS Industrial Power Systems R301MKII RF Power Supply

9600730034